Buy RigExpert USA for RigExpertCare™ Warranty Service and Better Support, Guaranteed !
RigExpert AA-30 – HF Antenna Analyzer (0.1 to 30 MHz)
PLEASE NOTE: DUE TO A HIGH RATE OF DAMAGED ANALYZER RETURNS THROUGH EBAY AND AMAZON, RIGEXPERT USA MAY NOT WARRANTY ANALYZERS RE-SOLD ON AMAZON OR EBAY. PLEASE USE CAUTION WHEN MAKING YOUR PURCHASE FROM NON-AUTHORIZED DEALERS.
RigExpert AA-30 is a powerful antenna analyzer designed for testing, checking, tuning or repairing antennas and antenna feedlines.
Mainly, these are SWR (Standing Wave Ratio) and impedance measurement instruments (vector impedance analyzers).
Easy-to use measurement modes, as well as additional features such as connection to a personal computer (to plot Smith charts, etc.), make RigExpert AA-30 attractive for professionals and hobbyists. It is quite important that graphical display of various parameters over a wide frequency range is a key feature of these analyzers which significantly reduces the time required to adjust an antenna.
The following tasks are easily accomplished by using RigExpert AA-30:
Rapid check-out of an antenna
Tuning an antenna to resonance
Antenna SWR and impedance measurement and comparison before and after specific event (rain, hurricane, etc.)
Making coaxial lines or measuring their parameters
Cable testing and fault location
Measuring capacitance or inductance of reactive loads
Frequency range: AA-30: 0.1 to 30 MHz, AA-54: 0.1 to 54 MHz
Frequency entry: 1 kHz resolution
SWR measurement range: 1 to 10
SWR measurement for 50 and 75-Ohm systems
SWR display: numerical or easily-readable bar
R and X range: 0-1000, -1000-1000 in numerical mode, 0-200, -200-200 in graph mode
– SWR at single or multiple (AA-54 only) frequencies
– SWR, R, X, Z, L, C at single frequency
– SWR graph, 100 points
– R, X graph, 100 points
– Connector type: UHF (SO-239)
– Output signal shape: rectangular, 0.1-10 MHz (AA-30)
– Output power: about +13 dBm (at 50 Ohm load)
– Two 1.5V, alcaline batteries, type AA *
– Two 1.2V, 1800-2700 mAh, Ni-MH batteries, type AA *
– Max. 3 hours of continuous measurement, max. 2 days in stand-by mode when fully charged batteries are used
– When the analyzer is connected to a PC or a DC adapter with USB socket, it takes power from these sources
– 128×64 graphical backlit LCD
– 6×3 keys on the water-proof keypad
– AA-30:menus and help screens in English language
– USB connection to a personal computer
Dimensions: 22X10X3.6 cm (9X4X1.5″);
Operating temperature: 0-40 C (32-104 F)
Weight (including batteries): 400g (14 Oz)
Warranty: 2 years (RigExpertCare Provided under RigExpert USA & PNC Engineering’s service guaranty)
*Note: Analyzer subject to be replaced with current model